Stroke Start/End Line Cap
This is the shape to use at the start and end of any line or outline of a Part that is a shape.
Stroke Line Join
Specifies the type of shape to use when joining lines in a Part that is a shape.
Stroke Miter Limit
A miter forms a corner by beveling the ends of two joined lines on a Part that is a shape. When two line segments meet at a sharp angle, the miter may extend beyond the thickness of the line that defines the shape outline.
Stroke Dash Cap
Specifies the shape to be used on dashes when a line or shape Part is drawn using dashes instead of a continuous line. Only applicable if Stroke Dash Gap Length is greater than 0.
Stroke Dash Offset
Specifies the distance in pixels within the dash outline where a dash begins.
Stroke Dash Length
Specifies the length in pixels of a dash in a dash outline.
Stroke Dash Gap Length
Increasing the value above 0 will make a line or outline of a shape Part to be drawn using dashes instead of a continuous line.