Start Angle
The start angle in degrees where the first major spoke will be drawn. The angle to use is the angle pointing towards the centre of the hub spoke.
Angle Interval
The additional angle where each subsequent major spoke should be drawn. Negative values draws the major spokes in an anti-clockwise direction.
Spoke Length
The spoke length of the first major spoke.
Spoke Length Inc
The distance to add to the previous major spoke length as each major spoke is drawn.
Spoke Qty
The total number of major spokes to draw.
Centre Offset
The distance from the centre of the hub spoke where the major spoke should stop being drawn.
Arc Centre Offset
Draw an arc at the distance of the centre offset.
Small Arc (Optional)
When enabled the arc around the centre offset is drawn via the smallest angle, i.e. draws the opposite arc.
Arc IS Circle (Optional)
When enabled the arc becomes a full circle.
Arc Stroke Width (Optional)
The width of the centre offset arc.
Show Cross Hairs
Shows cross hairs at the centre of the hub spoke to allow alignment of other Parts to the centre of the hub spoke.