Most of the commonly reported issues and questions are answered in the Frequently Asked Questions (FAQ) option under the Support menu of this website.
*** PLEASE NOTE ***
Your forum account is not the same as the account used in the shop. They are completely separate accounts.
1st December: A new version of the GoFlight Interface Tool for MSFS is now available.
12th November: A new version of the GoFlight Interface Tool for X-Plane is now available.
6th June: A new version of Virtual Flight Sim Hardware is now available (huge update)
21st November: A new version of the GoFlight Interface Tool for FSX/FSXSE/P3D is now available.

A interesting finding

opcartmellopcartmell
in General
I'm trying to program my GoFlight modules to work with the FBW A320NX. I've found that the aircraft will not taxi or takeoff without veering hard right while on the ground when GIT is running. Interestingly, if I start Detective the plane will once again taxi and takeoff in a controllable fashion. When in the air, this does not seem to occur. I've searched for interference and can find none. BTW, I use the Honeycomb Alpha Yoke and CHpedals. If anyone has any suggestions I'd listen intently.
Tagged:

Comments

  • admin_ppsadmin_pps
    Untick Enable Joysticks in the GIT Settings tab in case you have assigned an axis via GIT.

    Best wishes
    Steve
  • opcartmellopcartmell
    Joysticks is unchecked; however, I do see this entry in the log "06:28:58 Loading Joysticks". When using the outside view of the sim, I can see the rudder and nosewheel go hard right when GIT is enabled.
  • fsamfsam
    do you have checked the rudder trim at ECAM page, maybe there is an unintentionally input e.g. from GF-LGT2 or other module? Best regards Ralf
  • opcartmellopcartmell
    Here's what I know so far. If I start the FBW 330 and then GIT, the plane will take a hard, uncontrollable turn to the right. If I then start Detective, the plane is steerable again. If I then cancel Detective, the plane remains steerable. I've searched the bespoke events I have developed and can find no interfering commands. I'll keep looking, but at least I've found a workaround.
  • admin_ppsadmin_pps
    Does it happen during synchronising buttons and switches (see the GIT log)?

    Best wishes
    Steve
  • opcartmellopcartmell
    Steve, Tried to send a copy of the log but it was so long it wouldn't fit.
  • admin_ppsadmin_pps
    Zip it up and attach it to your post.

    Thx
    Steve
  • opcartmellopcartmell
    Steve, Wanted you to know that since my last post, I've had no failures. If I get another I'll zip up the log and send it.
Sign In or Register to comment.

© Vanilla Keystone Theme 2025