peeps82
Most of the commonly reported issues and questions are answered in the Frequently Asked Questions (FAQ) option under the Support menu of this website.
*** PLEASE NOTE ***
Your forum account is not the same as the account used in the shop. They are completely separate accounts.
Your forum account is not the same as the account used in the shop. They are completely separate accounts.
1st December: A new version of the GoFlight Interface Tool for MSFS is now available.
12th November: A new version of the GoFlight Interface Tool for X-Plane is now available.
6th June: A new version of Virtual Flight Sim Hardware is now available (huge update)
21st November: A new version of the GoFlight Interface Tool for FSX/FSXSE/P3D is now available.
peeps82
Comments
-
Hi Rob, Thank you for the reply - i have tried it in two different powered usb hubs and in the usb on the front of the pc -but not to the ones directly on the motherboard (only via the powered hubs) As i said earlier i got it working on a new Hub, but after i disconnected it to mount the panel it would not work - the…
-
i am now defeated - thought i had got it working - disconnected the panel to mount it properly - when i reconnected same problems pc usb erros saying device not loaded correctly - or sometimes it does - goflight config does not see it - if i connect and reconnect it it will work start prepar it turns panel off - only way…
-
Finally resolved the GF46 panel problems - i think main culprit was a dodgy USB hub, got a new one today - Bingo it works !!! Thanks to Rob and Steve for the help they provided - works how a good forum should. Peeps82
-
Hi Rob, I have got a little further - i can now get the panel to work - copied the data bridge `launch addon' from the EXE xml doc to the DLL doc - only problem is i have disconnect and re-connect the panel to get Prepar to see it and the panel has `frozen' a couple of times - at the moment i am assuming that this is a…
-
Steve, thanks for the reply, i have just tried the panel on my other windows 7, FSX pc and it seems to work ok so i assume the problem is windows 10 related - i think i have tried the older drivers - but i will try again. thanks again
-
Steve, Thanks for the reply, The panel is in a USB 2 port - did as you suggested installed config with panel connected - panel did not light up, when i launched config after reboot config says no panels connected - re-connected panel - panel shows on config - ADF in green on panel and hyphen 1 hyphen in red panel does not…