curbz
Most of the commonly reported issues and questions are answered in the Frequently Asked Questions (FAQ) option under the Support menu of this website.
*** PLEASE NOTE ***
Your forum account is not the same as the account used in the shop. They are completely separate accounts.
Your forum account is not the same as the account used in the shop. They are completely separate accounts.
1st December: A new version of the GoFlight Interface Tool for MSFS is now available.
12th November: A new version of the GoFlight Interface Tool for X-Plane is now available.
6th June: A new version of Virtual Flight Sim Hardware is now available (huge update)
21st November: A new version of the GoFlight Interface Tool for FSX/FSXSE/P3D is now available.
curbz
Comments
-
Very helpful, thanks so much Ralf!
-
Ralf, may I ask how you are setting the Managed/Selected AP mode events using the rotary's P/B? I have so far been unsuccessful with this. Thanks in advance!
-
good to hear Ray - thanks for sharing the solution
-
great, thanks
-
yes that does sound feasible Ray regards Darren (curbz)
-
Thanks Detlef - I will try this. Did you experience the same as me i.e GIT starts ok but hangs when PMDG aircraft loaded?
-
yes, batch file, windows script file or similar. So my theory (and it is only a theory) is this: I'm assuming GoFlight config program loads a configuration when it starts - either a default one or the last used config profile? Let's say this profile is called "FSDefault.gfc" and that you also have 2 other config profiles:…
-
A workaround could be to write a little script to copy the desired goflight config file to the default one that gets loaded and have SimStarterNG run the script - that might work?
-
Hi Steve, I tested with 32bit version and the same issue exists. Regards Darren
-
sure, will do Steve, I'll report back
-
I am experiencing the same symptom. Did not experience this issue before on P3D v4.3 and earlier version of GIT. This seems to have come about after upgrading to P3Dv4.5HF1 and upgrading GIT version to latest 64bit version. I'm using v2.28 GoFlight drivers for MCPPro and EFIS. I'm running Windows 10. Most of the time it…
-
thanks for the quick reply Steve and offering to look at the possibility of adding some support. The board does not require any specific data format - so just the ability to open the port and set the communication settings e.g.baud rate etc. then some read/write commands. Finally to close the port. This would be a great…
-
thanks for your reply Steve. I uninstalled v1.8 and went back to 1.7 as I'm using currently only using XP10 - VS now working. Used your B733.zip rename tip - works very nicely - thanks :)